Same-day diagnostics, no charge
Drop your drone before 11 a.m. and we will have a diagnostic report and quote back to you the same day. No diagnostic fee, no obligation. You approve the work before we start.
Drone repair Houston TX starts with a free diagnostic and a straight answer about what failed. We fix crash damage, swollen LiPo batteries, gimbal shake, and motor burnout for DJI, Autel Robotics, and Parrot pilots across Harris County. Most jobs are done in 24 to 48 hours.
Upfront optionsNo work before you approve it
Respectful serviceClean floors, clear communication
Real guaranteesRepairs backed in writing
Local techniciansLicensed local professionals
Houston Drone Repairs Pros has been fixing drones in Houston since 2018. We handle everything from a cracked propeller on a Holy Stone trainer to a dead gimbal on a Skydio work rig. Our bench techs run every unit through a full diagnostic before quoting, so you know the real problem before you approve a dollar of work.
What separates us is turnaround and parts depth. We stock propellers, brushless motors, ESCs, and camera modules for the brands Houston pilots actually fly, which means fewer week-long waits. If you need drone repair near me Houston TX same day, call before 11 a.m. and we will usually have you airborne by close of business.
Every drone that comes through our door gets the same treatment: a full bench diagnostic, a written quote, and a test flight before pickup. We work on camera rigs, racing quads, and commercial platforms from DJI, Autel Robotics, BetaFPV, and iFlight. Whether you need affordable drone repair in Houston Texas or a full rebuild after a hard crash, we have the tools and the parts on hand.
Drone Repair
General drone repair Houston TX covers whatever is keeping your aircraft grounded, from a cracked arm to a dead flight controller. We diagnose on a multimeter and oscilloscope, then quote before we touch a screw.
Explore →
Drone Battery Replacement
Swollen or puffed LiPo batteries are a fire risk and a flight risk. We test cell balance and internal resistance, then swap in a matched pack. Bring your charger so we can verify it is not overcharging.
Explore →
Drone Propeller Replacement
Bent or chipped propellers cause vibration that eats motor bearings over time. We replace full sets, balance them on a propeller balancer, and check motor shafts for runout before you fly again.
Explore →
Drone Motor Repair
Motor failure usually shows up as a hot bell, a grinding noise, or a sudden yaw drift. We test each brushless motor under load, replace failed bearings or the whole motor, and re-check ESC timing.
Explore →
Drone Gimbal Repair
A shaking or stuck gimbal ruins every shot. We rebuild gimbal arms, replace ribbon cables, and run a full gimbal calibration tool pass so the horizon stays level through a full tilt range.
Explore →
Drone Camera Repair
Camera black screen, blurry footage, or a cracked lens all land on our bench. We swap camera modules, reseat ribbon connectors, and test video feed at range before the drone leaves the shop.
Explore →
Drone Firmware Updates
Firmware issues cause flyaways, failed compass calibration, and dropped signal. We flash the latest manufacturer firmware, verify sensor handshakes, and test-fly to confirm no error codes remain.
Explore →
Drone Software Repair
Corrupted flight logs, failed app pairing, and bricked updates are software problems, not hardware ones. We reflash the flight controller, restore factory parameters, and re-bind your controller and receiver.
Explore →
Drone Water Damage Repair
Water damage is a race against corrosion. We strip the airframe, clean boards in an ultrasonic bath, replace corroded connectors, and dry everything before power-up. Bring it in the same day it gets wet.
Explore →
Drone Crash Repair
Crash damage rarely stops at the frame. We inspect carbon fiber frames for hairline cracks, test every motor and ESC, and replace landing gear and antennas as needed. Most crash repairs finish in 48 hours.
Explore →
Drone Frame Repair
A cracked carbon fiber frame flexes in flight and throws off your IMU. We replace damaged arms and plates, re-torque every fastener with a hex driver set, and verify frame rigidity before reassembly.
Explore →
Drone Remote Controller Repair
Sticky sticks, dead buttons, and broken antennas all get fixed here. We replace gimbals in the controller, repair charging ports, and test signal output with a multimeter before handing it back.
Explore →
Drone Charging Hub Repair
A charging hub that will not balance cells can cook a battery. We test each port under load, replace failed charging boards, and confirm every bay charges to the correct voltage cutoff.
Explore →
Drone Sensor Calibration
Vision and obstacle-avoidance sensors drift after hard landings. We recalibrate on an IMU calibration stand and verify obstacle detection at close range before the drone goes back out.
Explore →
Drone Compass Calibration
Compass calibration error is one of the most common pre-flight failures. We demagnetize the compass, recalibrate in an open area away from rebar, and confirm heading accuracy against a known reference.
Explore →
Drone IMU Calibration
A drifting IMU causes toilet-bowl effect and unstable hover. We level the aircraft on an IMU calibration stand, run the full calibration sequence, and test hover stability before pickup.
Explore →
Drone Antenna Repair
Signal loss at range usually traces back to a damaged antenna or connector. We replace antennas, re-solder U.FL and SMA connections, and range-test the link before the drone leaves the bench.
Explore →
Drone Landing Gear Repair
Bent or missing landing gear tips the aircraft on takeoff and can crack the frame. We replace gear sets, check mounting points for stress cracks, and verify the drone sits level on a flat surface.
Explore →
Drone Battery Charging Station Repair
Multi-bay charging stations fail one port at a time. We test each bay, replace burned-out charging circuits, and verify balance-charge behavior so your packs stay healthy.
Explore →
Drone Payload Repair
Payload mounts, release mechanisms, and drop systems take a beating. We repair mounting hardware, replace servos, and test payload release cycles before the unit goes back into service.
Explore →
Drone Thermal Camera Repair
Thermal camera repair means checking the sensor, shutter, and calibration. We test temperature accuracy against a reference source, repair lens assemblies, and confirm the video feed is clean.
Explore →
Drone LiDAR Repair
LiDAR units are precision instruments. We inspect optics, clean sensor windows with a compressed air blower, test scan returns, and repair mounting hardware on survey and mapping drones.
Explore →
Drone Custom Builds
We build FPV racers, cinematic rigs, and commercial platforms from the frame up. You pick the motors, ESCs, and flight controller; we handle soldering, wiring, firmware, and the maiden flight.
Explore →
Drone Maintenance Services
Regular maintenance catches small problems before they become crashes. We clean motors, inspect propellers, check battery health, update firmware, and log everything so you know the aircraft's condition.
Explore →
Drone Diagnostics
Not sure what is wrong? Our full diagnostic runs the aircraft through motor, sensor, battery, and signal tests. You get a written report and a quote before any repair work begins.
Explore →
Drone Parts Replacement
We stock propellers, motors, ESCs, gimbals, landing gear, and camera modules for DJI, Autel Robotics, Hubsan, and Potensic. Most common parts are on the shelf, so repairs do not wait on shipping.
Explore →
Drone Accessory Repair
ND filters, lens hoods, controller lanyards, and carrying case hardware all get repaired here. If it attaches to your drone and it is broken, bring it in with the aircraft.
Explore →
Drone Transmitter Repair
Transmitter repair covers stick modules, switches, antenna connectors, and charging circuits. We test output power and range, then repair or replace the failed component.
Explore →
Drone Receiver Repair
A failed receiver means no control link. We replace receiver boards, re-bind to your transmitter, and range-test the connection. Works on DJI, BetaFPV, and iFlight receiver types.
Explore →
Drone Flight Controller Repair
Flight controller failure can ground an otherwise healthy drone. We test gyro, accelerometer, and barometer outputs, reflash firmware, and replace the board if the hardware is dead.
Explore →
We are not a general electronics shop that happens to take drones. Every tech on our bench works on multirotors daily, and we keep the parts and calibration tools that most shops do not stock.
Drop your drone before 11 a.m. and we will have a diagnostic report and quote back to you the same day. No diagnostic fee, no obligation. You approve the work before we start.
We stock propellers, brushless motors, ESCs, gimbals, and camera modules for DJI, Autel Robotics, and the trainer brands. That means most repairs finish in 24 to 48 hours instead of a week.
Every repaired drone gets a hover test and a range check before it leaves the shop. If it does not fly right on our bench, it does not go home with you. That is the whole policy.
We quote every job before we start. Typical 2026 pricing for drone repair in Houston runs from a simple propeller swap to a full crash rebuild, and you will know the number before we touch a screw.
Not sure? Tell us what you see →Bring your drone to our Houston shop or ship it in. Include the battery and controller if you can. We log the aircraft and start the diagnostic the same day it arrives.
We test motors, ESCs, sensors, battery health, and signal output. You get a written report with the failed components and a flat quote for the repair.
Nothing gets repaired until you say go. If you decline, we reassemble the drone and you pay nothing for the diagnostic. Simple as that.
We replace the failed parts, recalibrate sensors, and run a hover and range test. Most standard repairs finish within 24 to 48 hours of approval.
We hand back your drone with a summary of what was fixed and any maintenance notes. You fly it. If something is not right, bring it back and we will make it right.
Bring your drone to our Houston shop or ship it in. Include the battery and controller if you can. We log the aircraft and start the diagnostic the same day it arrives.
Houston heat, humidity, and the occasional hard landing take a toll on drones. These are the failures we see most often, and how we get pilots back in the air.
Ask a pro →Heat is brutal on LiPo batteries. We test cell balance and internal resistance, replace swollen packs, and check your charger to make sure it is not overcharging. Store packs at 50 percent charge in a cool spot and they last longer.
Gimbal malfunction usually means a bent arm, a worn ribbon cable, or a failed motor. We rebuild the gimbal, replace the cable, and run a full calibration pass. You get a level horizon through the entire tilt range.
A grinding motor or one that runs hot is on its way out. We test each brushless motor under load, replace bearings or the whole motor, and verify ESC timing. Do not fly on a suspect motor.
Compass errors often come from magnetic interference or a damaged compass module. We demagnetize, recalibrate away from rebar and metal, and confirm heading accuracy. If the module is bad, we replace it.
“Crashed my Mavic into a tree in Memorial Park and cracked the gimbal arm. They had the part in stock, fixed it in a day, and test-flew it before I picked it up. Footage is level again. Way cheaper than I expected.”
Rafael M.Homeowner, Memorial
✓ Verified“My Autel had a compass calibration error that I could not clear no matter what I tried. They demagnetized it, recalibrated, and explained what caused it. No upsell, just the fix. I fly commercially and this is my shop now.”
Priya N.Commercial Pilot, Energy Corridor
✓ Verified“Two batteries swelled up after a summer of flying in the heat. They tested all four packs, replaced the bad two, and checked my charger. Told me to store them at half charge. Straight talk, fair price.”
Darnell W.FPV Pilot, Third Ward
✓ VerifiedWe serve pilots from Downtown Houston out to Katy, Clear Lake, and The Woodlands Area. Whether you fly commercially in the Energy Corridor or race quads in Spring Branch, our shop is a short drive or a prepaid shipping label away. We cover Harris County and the surrounding communities with the same turnaround and the same pricing.
Not sure you're in range? Call with your ZIP code—we're always happy to check.
Straight answers to the questions we hear most from Houston pilots. If yours is not here, call us at +1 281 555 4468.
+1 281 555 4468 →Most repairs run $149 to $349 for standard jobs like motor, gimbal, or camera fixes. A full crash rebuild with frame and sensor work runs $399 to $899. The bench diagnostic is $49 flat and gets credited toward the repair if you approve the work. You get a written quote before we start.
Our shop serves all of Houston and Harris County, from Downtown and the Heights to Katy, Clear Lake, and The Woodlands Area. Drop off in person or ship your drone in. We also cover 77069, 77068, 77061, 77060, 77063, and 77062 with fast turnaround.
We work on DJI, Autel Robotics, Parrot, Skydio, and trainer brands daily, and we stock the parts that matter. Every repair gets a test flight before pickup. That is the standard we hold ourselves to, and it is why commercial pilots around the Energy Corridor keep coming back.
We offer 24/7 emergency repair booking for commercial operators who are grounded mid-job. Call +1 281 555 4468 any time and we will get your aircraft on the bench first thing. Standard turnaround is 24 to 48 hours once we have the parts in hand.
Ask three things: do they stock parts, do they test-fly before pickup, and do they quote before they start. A shop that cannot answer all three is guessing. We do all three on every job, and we have been fixing drones in Houston since 2018.
Grounded drone? Bring it in for a $49 diagnostic and a written quote. Same-day turnaround on most repairs, and we test-fly every aircraft before it goes home. Call +1 281 555 4468.
Call now →Call us at +1 281 555 4468 or stop by the shop. We are open Monday through Friday, 8 a.m. to 6 p.m., and we answer emergency calls 24/7 for commercial operators. Most diagnostics are done the same day you drop off.